Risoluzione dei problemi del motore a ingranaggi

Creato il 05.17

Troubleshooting of Gear Motor

电机使用中的常见故障包括不转动、速度和扭矩异常、噪音过大、内外泄漏和异常发热等。故障诊断和排除的一般方法如下表所示。下表列出了使用中涡轮内啮合齿轮电机的一些常见故障现象和排除方法。

常见故障及使用中的摆线内齿轮电机故障排除

Fault phenomenon	原因分析	Exclusion Method
1. The motor does not turn	①The hydraulic pump is not started or is not turning in the correct direction	① Start the hydraulic pump or correct the pump's rotation direction
	②油箱储油量不足	②Add to the specified oil amount
	③The directional valve is in the neutral position	③Switching Directional Valve
	④The pressure setting value of the overflow valve is too low	④System pressure adjusted to the specified value
	⑤Motor output torque is insufficient	⑤Replace motor
2. Excessive noise during operation	①There is air in the hydraulic system	①Identify the intake cause and eliminate air in the oil
	②Suction	②Increase fuel supply
	③Failure of internal components such as bearings in the motor	③Replace bearings and other damaged parts
3.内、外泄漏过大	①Sealing element damage causes internal and external leakage	①Replace sealing components
	②Motor parts have air holes, sand holes, cracks, etc.	②Replace parts
	③Loose bolts	③Tighten the bolts
4. Abnormal fever	①Hydraulic oil temperature is too high	①Increase cooling capacity
	②Motor efficiency decreases	②Replace consumable parts
	③Abnormal wear	③Replace motor

Lascia i tuoi dati e
ti contatteremo.

Phone

WeChat